Removing and installing radioR, MMI (up to week 21/09): Audi Q7
Step-by-step removing and installing radioR, MMI (up to week 21/09) for the Audi Q7: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi Q7 (4L, 2005–2015)
📋 Procedure
- When renewing control unit, select "„Replacement“" function for appropriate control unit in "„Guided Fault Finding“".
- Switch off ignition and all electrical equipment and remove ignition key.
- Remove luggage compartment side trim (right-side) General body repairs, interior70Trim; Removing and installing luggage compartment side trim.
- Unplug connectors (2) and (3) on radioR(1).
- Fit protective cap for cable connectorVAS 6223/9(1) onto MOST bus connector (2).
- Disconnect aerial wires (4).
- Unscrew bolts (arrows).
- Detach radioR(1) from retainer.
- Remove speech input control unit J507.
- Installation is performed in reverse sequence.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Tightening torques for gearbox
- Checking air conditioner components on vehicles with high-voltage system
- Removing and installing control motor for left footwell temperature flap V411
- Operation of heater coolant shut-off valve
- Removing and installing high-voltage wiring harness for hybrid battery PX1
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.