Removing and installing radio navigation system "“RNS 510”" — AUDI

🧭 Before you start

Fits: platform codes S1, 2H

• Special tools named: locking bar

Don't miss

• The number and the location of connections on the unit can vary depending on the type of radio navigation system.

📋 Procedure

1. Remove any CDs left in the unit Operating manual.
2. Switch off ignition and all electrical loads, and pull out ignition key.
3. Unclip compartment in middle on dash panel at points marked with (arrows).
4. Release connector (arrow) and disconnect.
5. First, turn covers (arrows), and then remove them, or remove any accessories fitted here (telephone Touch Kit, drink holder or similar).

6. Remove securing bolts (arrows).
7. Remove cover frame and unlock and disconnect connectors of switches installed in cover frame.
8. Unscrew securing bolts (arrows) from radio navigation system.
9. Pull radio navigation system out of installation slot until you can access connectors at rear of unit.
10. Press together locking element of multi-pin connector in (direction of arrow).
11. Swing locking bar in (direction of arrow). This causes the connector to be pushed out.
12. Release all aerial connections (arrows) and pull them off. [Note: The number and the location of connections on the unit can vary depending on the type of radio navigation system.]
13. Plug connectors into radio navigation system and lock.
14. ⚠ Risk of damage to display and operating keys!When inserting the radio navigation system into the installation slot by pressing against the display or operating keys, the unit could become damaged.When inserting the radio navigation system never press against the display or operating keys. — Push radio navigation system straight into dash panel.
15. Screw in and tighten the 4 securing bolts (arrows).
16. Deactivate anti-theft coding .
17. Check coding of radio navigation system and re-code if necessary .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Renewing front hydraulic bonded rubber bush in subframe – Audi
• Adjusting panel – Audi A8 D4 · 1 torque figures
• Removing and installing expansion valve with refrigerant shut-off valve 2 for hybrid battery N517
• Cleaning evaporator in front and rear air conditioning unit with ultrasonic A/C cleanerVAS 6189A
• Removing, installing and checking auxiliary air heater element Z35 with auxiliary air heater control unit J604