Removing and installing output shaft: Audi A3

🧭 Before you start

Fits: Audi A3 (8L, 1996–2003)

Don't miss

• Sealing lip and spring of seal must not be damaged.

📋 Procedure

1. Position thrust piece3002 onto flange of output gear.
2. Secure bearing cover in vice using soft jaws (A).
3. Knock tapered roller bearing outer race slightly out of bearing cover by carefully tapping on alternate sides.
4. Pull tapered roller bearing outer race out of bearing cover.
5. Check bearing cover for damage.

6. Remove securing bolt .
7. Tighten bearing support ring. Apply sealing compoundAKD 456 000 02 to securing bolt before fitting and tighten bolt.
8. Carefully install oil seal. [Note: Sealing lip and spring of seal must not be damaged.]
9. Drive in seal onto stop.
10. Insert output shaft with tapered roller bearing inner race, then drive in outer race.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing glove box/knee bolster – Audi A8 D3
• Removing and installing carrier for centre armrest – Audi
• Removing and installing three-point seat belt – Audi A8 D3
• Removing and installing front side airbag – Audi A8 D3
• Removing and installing front passenger's knee airbag – Audi