Removing and installing operating and display unit (panel van/dropside) — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove centre dash panel trim 68.
2. Remove bolts (2) (1.5 Nm) and remove operating and display unit (1) from dash panel. — 1.5 Nm (1.1 lb-ft)
3. Separate connectors.
4. Disconnect cables from operating and display unit.
5. Secure cables to operating and display unit .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing ignition coils – Audi A8 D3
• Removing and installing gear oil pump
• Draining and changing gear oil / filling up after performing repairs
• Removing and installing fuel rail – Audi 2.0
• Removing and installing telephone transmitter and receiver unit R36 · 1 torque figures