Removing and installing navigation aerial (GPS)R50 (Saloon) — AUDI

🧭 Before you start

Fits: Audi A6 C5 (4B)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Remove rear lid trim: General body repairs, interior70.
4. Unscrew nut (1) (35 Nm) at rear lid (2). — 35 Nm (26 lb-ft)
5. Carefully guide aerial wire (1) out of left-hand opening in rear lid (2).
6. Move aside foam sleeve (3) covering connector and unplug connector (4).
7. Installation is performed in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing holder for control motor V108 and V411
• Removing heat exchanger of rear air conditioning unit from air conditioning unit and re-installing
• Servicing automatic gearbox 01L, four-wheel drive — Removing and installing selector shaft
• Removing and installing printed circuits for mechatronic unit
• Removing and installing motor plate (rear) and cable for sunroof sun blind · 1 torque figures