Removing and installing mounting bracket, Audi A1 quattro — AUDI
Removing and installing mounting bracket, Audi A1 quattro on Audi: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A1 (8X, 2010–2018)
- Renewed: self-locking nuts
Don't miss
- Renew self-locking nuts.
📋 Procedure
- Remove dash panel cover (driver side) General body repairs, interior68Shelves / trim panels; Removing and installing dash panel cover (driver side).
- Remove crash bar General body repairs, interior70Central tube for dash panel; Exploded view - central tube for dash panel.
- To release operating rod for clutch master cylinder, pull clutch pedal slightly towards passenger compartment.
- Press both sides of retaining clip inwards using pliers T10005(arrows).
- Remove nuts (1, 2).
- Carefully remove mounting bracket (3) (to do this, get a second mechanic to counterhold clutch master cylinder until it is disengaged from mounting bracket). [Note: Renew self-locking nuts.]
- Bring clutch pedal into position at clutch master cylinder.
- Press on clutch pedal so that retaining clip snaps into place in mounting on clutch pedal (3).
- Install crash bar General body repairs, interior70Central tube for dash panel; Exploded view - central tube for dash panel.
- Install dash panel cover (driver side) General body repairs, interior68Shelves / trim panels; Removing and installing dash panel cover (driver side).
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Repairing driver and passenger airbag10.92 > 06.94 (Airbag II)
- Final control diagnosis for gearbox with hydraulic control E17
- Connecting vehicle diagnosis, measurement and information system VAS 5051 orfault reader V.A.G 1551 and selecting functions
- Dismantling and assembling differential (gearbox with no oil pump)
- Checking operation of manual convertible top actuator 07.94 ä
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.