Removing and installing moulded headliner, panel van — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

• Renewed: if necessary

Don't miss

• Before installing, check fasteners for damage and renew if necessary.

📋 Procedure

1. Switch off ignition.
2. Remove light and switch unit from storage compartment 96.
3. Remove roof grab handles .
4. Remove sun visors .
5. Remove roof gallery storage compartment .

6. Remove net partition .
7. Remove upper A-pillar trims .
8. Remove lower B-pillar trims, panel van .
9. Remove upper B-pillar trims, panel van .
10. Unscrew plastic pin (1) and pull spreader rivet (2) out of mountings in roof.
11. Remove remaining connections (arrows) as described.
12. Pull moulded headliner (3) out of door seal mouldings and remove from vehicle. [Note: Before installing, check fasteners for damage and renew if necessary.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Exploded view - steering rack, track rods
• Removing and installing centre crash sensor for X/Y axis G858
• Gearbox adaption
• Exploded view - poly V-belt drive, vehicles up to model year 2013
• Checking fuel gauge sender 2 G169 - A5 up to model year 2011, A4 up to model year 2012, rest-of-world vehicles with four-wheel drive, USA vehicles with front-wheel drive/four-wheel drive