Removing and installing monitor for reversing camera — AUDI

🧭 Before you start

Fits: platform codes 2EA, 2ED, 2EH, 2EX, 2EB, 2EE, 2EK, 2FC, 2FF, 2FL, 2FZ, 2FG, 2FM

Don't miss

• After installing, check operation of reversing camera.

📋 Procedure

1. Switch off ignition and all electrical loads, and pull out ignition key.
2. Using removal wedge3409, carefully lever out centre console cover (arrow).
3. Complete remove cover (1) from the clips holding it in.
4. Unscrew securing bolts (arrows) from right dash panel trim.
5. Slightly pull out trim in direction of (arrow).

6. Unclip trim from dash panel (arrows).
7. Remove dash panel trim.
8. Unclip trim on left of dash panel in the same manner.
9. Unscrew and remove the two securing bolts (arrows).
10. If installed, remove radio system/radio navigation system Communication91.
11. Unscrew and remove the two securing bolts (arrows).
12. Remove storage compartment together with monitor (Pfeil), and place it on left of dash panel.
13. Pull monitor wiring upwards out of radio installation slot.
14. Release and disconnect connector (A) for video signal, and connector (B) for voltage supply and audio signals.
15. After installing, check operation of reversing camera.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures