Removing and installing MMI display (up to week 35/08): Audi A6 C6

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Remove instrument cluster trim panel General body repairs, interior70.
4. Release the connector cover (2) by pressing the tab (1) in the direction of the (arrow A).
5. Pivot the connector cover (2) upwards ((arrow B)) and unplug the connector.
6. Unscrew bolts (arrows) (2 Nm) and detach display. — 2 Nm (1.5 lb-ft)
7. Installation is performed in reverse sequence.
8. Be sure that the connector cover is properly engaged.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Adjusting selector mechanism - vehicles from 05.01 onwards, vehicle ID No. 4B-1-053 718 ▶
• Removing and installing injectors with fuel rail – Audi 2.7
• Checking misfiring detection on vehicles with engine code letters "“ARE”", "“AZA”" and "“BES”"
• Removing gearshift cover console – Audi TT Mk1 · 1 torque figures
• Removing and installing central tube retainer (Roadster) · 1 torque figures