Removing and installing lower A-pillar trim — AUDI
Removing and installing lower A-pillar trim on Audi: 13 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1.5 Nm (1.1 lb-ft) | Tightening torque |
| 4 Nm (3.0 lb-ft) | Tightening torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove lower part of trim
- Remove cross-head screws
- Unclip trim, starting at bottom
- Check seating and condition of clips and correct if necessary
- Hook upper retaining lug in
- Press trim on in area of clips
- Install cross-head screws
- Remove cross-head screw
- Unclip trim, starting at bottom
- Check seating and condition of clips and correct if necessary
- Hook upper retaining lugs in
- Press in lining around clip
- Install cross-head screw
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing bonnet, adjusting bonnet – Audi · 5 torque figures
- Removing sunroof – Audi A2 · 4 torque figures
- Removing and installing toothed belt - vehicles with hydraulically damped tensioning roller · 2 torque figures
- Removing and installing bevel box - vehicles with 6-cylinder engine · 3 torque figures
- Installing gearbox - Audi A4, A5 with 1.8 ltr. and 2.0 ltr. TFSI engines · 3 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix → · How these pages are made →Workshop data on this page last updated 20 Sep 2026.