Removing and installing left vent temperature sender G150 — AUDI

🧭 Before you start

Fits: platform code 42

Don't miss

• The glove compartment must be removed on right-hand drive vehicles 68.
• To avoid possible interchange with other identical connectors, mark the connector (B) to the left vent temperature sender G150.
• On insertion, make sure the broad guide (D) at the left vent temperature sender G150(A) is opposite the mount (C) at the air conditioning unit.

📋 Procedure

1. Switch off the ignition.
2. Remove the driver side dash panel cover 68. [Note: The glove compartment must be removed on right-hand drive vehicles 68.]
3. Remove the centre console left side trim 68.
4. Screw out the bolt (B) and detach the footwell vent air duct (A).
5. To avoid possible interchange with other identical connectors, mark the connector (B) to the left vent temperature sender G150.

6. Unplug the connector (B) at the left vent temperature sender G150(A).
7. Turn the left vent temperature sender G150(A) anti-clockwise (arrow) and pull it out of the air conditioning unit.
8. Replace the sealing ring (B) if damaged or defective.
9. On insertion, make sure the broad guide (D) at the left vent temperature sender G150(A) is opposite the mount (C) at the air conditioning unit.
10. Fit the footwell vent air duct .
11. Fit the centre console left side trim 68.
12. Fit the driver's side dash panel trim 68.
13. Interrogate the event recorder and erase any faults displayed.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures