Removing and installing LED module for daytime running light and side light L176/L177 - vehicles up to model year 2014 — AUDI
Removing and installing LED module for daytime running light and side light L176/L177 - vehicles up to model year 2014 on Audi: 10 steps.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A1 (8X, 2010–2018)
📋 Procedure
- Remove headlight housing .
- Remove bolts (arrows).
- Detach LED module (3) from headlight housing.
- Unplug electrical connector (2).
- Remove gas discharge bulb control unit .
- Remove bolts (1, 6).
- Pull out LED module (5)(arrow A), rotate around attachment point (4) for gas discharge bulb control unit (arrow B) and lift off.
- Unplug electrical connector (2).
- Check seal (1) between LED module and headlight housing for damage.
- Check seal (3) between LED module and headlight housing for damage.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing gas strut
- Removing and installing convenience system central control unit J393 - Avant
- Removing and installing roof trim strip – Audi A6/A7 C7
- Removing and installing trim panel for C-pillar on door – Audi
- Removing and installing heat shield for tunnel (rear) – Audi
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.