Removing and installing interior aerial 1 for entry and start authorisation R138 — AUDI

🧭 Before you start

Fits: Audi Q7 (4L, 2005–2015)

📋 Procedure

1. Shift selector lever to "“N”" position.
2. Switch off ignition and take out ignition key.
3. Unclip retaining frame for selector lever boot (1) from centre console and detach upwards (arrows).
4. Pull up boot for selector lever and turn inside out.
5. Release retaining spring (2) and remove selector lever display unit Y26(item 1) upwards.

6. Unplug electrical connector.
7. Use screwdriver (2) to lever out storage compartment (1) in centre console in direction of (arrow).
8. Reach through opening for storage compartment in centre console and press out mounting frame (1) for multimedia system operating unit E380 upwards (arrow).
9. Reach through opening for selector lever boot and pull mounting frame (1) for multimedia system operating unit E380 off upwards (arrow).
10. Unplug electrical connectors.
11. Fold insulation (3) for selector lever housing (arrow) upwards.
12. Remove bolts (1) and (2).
13. Unplug electrical connector (4).
14. Detach interior aerial 1 for entry and start authorisation R138(item 5).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing exhaust gas recirculation cooler - engine code letters BDG, BDH
• Removing and installing washer fluid reservoir - Audi A4, Audi S4
• Disconnecting centre silencer and rear silencer - vehicles with four-wheel drive · 1 torque figures
• Removing and installing selector lever – Audi A3
• Adjusting planet carrier