Removing and installing inner door cover - equipment version with power latching system — AUDI

🧭 Before you start

Fits: Audi Q7 (4M, 2015–)

📋 Procedure

1. Remove door trim (rear) General body repairs, interior70Door trim (rear); Removing and installing door trim (rear).
2. Unplug electrical connector (3).
3. Release fastener (arrow A) and pull cable (2) downwards off mounting bracket (arrow B).
4. Disengage cable at motor for power latching system (1).
5. Move electrical wiring harness (3) clear.

6. Turn spreader pins (arrows) 180° in anti-clockwise direction and pull out as far as catch.
7. Prise inner door cover (1) off inner door panel using wedge T10383/1.
8. Disengage grommets (2, 4) for cables.
9. Move cables into installation position and engage grommets in holes.
10. Press on inner door cover (4) until it engages and secure with spreader pins (3).
11. Install cable for motor for power latching system .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking combination valves for secondary air system for correct operation and leakage
• Removing and installing combination valves for secondary air system
• Renewing tailpipe – Audi A8 D3 · 1 torque figures
• 6-cylinder direct petrol injection engine (2.8 ltr. 4-valve) — Securing engine to engine and gearbox support · 1 torque figures
• Flywheel - exploded view · 1 torque figures