Removing and installing ignition/starter switchD — AUDI

🧭 Before you start

Fits: platform code 42

Don't miss

• Inspection seal (2) on base of switch must not be pulled off or damaged.
• Actuator (2) must engage in recess (1), as shown in illustration.

📋 Procedure

1. Take welding wire ∅ 1 mm and bend round at one end.
2. Then cut off welding wire.
3. File hook so that end is pointed.
4. Pull out steering wheel with adjuster as far as it will go and tilt it downwards.
5. Remove trim for steering column switch module 68.

6. Unplug electrical connector (1). [Note: Inspection seal (2) on base of switch must not be pulled off or damaged.]
7. Carefully make an incision in inspection seal (arrow) using a carpet knife, as shown in illustration.
8. To release catches (3)(arrow B), insert improvised tool (2) at positions shown (arrows A).
9. Pull out ignition/starter switch (1) and detach to left.
10. Actuator (2) must engage in recess (1), as shown in illustration.
11. Insert ignition/starter switch into steering lock housing until it engages audibly.
12. Install trim for steering column switch module 68.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing front seat backrest - standard seat, sports seat, super sports seat
• Removing and installing coolant pipe (rear right) - engine codes CAMA, CAMB, CAPA
• Checking fuel delivery rate of fuel system pressurisation pump G6 - A5 up to model year 2011, A4 up to model year 2012 (vehicles with four-wheel drive)
• Removing and installing alternator - vehicles with 2.0 ltr. TDI engine with SCR catalytic converter (PR number TD1)
• Removing and installing starter - vehicles with 2.0 ltr. TDI engine (PR number TD1)