Removing and installing ignition/starter switch, vehicles as of 09.2009 — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

Don't miss

• When installing the ignition/starter switch, ensure that the ignition/starter switch and the lock cylinder are in the same position, e.g. "“ignition on”". — Turn ignition key in lock cylinder to "“Ignition ON”" position.

📋 Procedure

1. ⚠ To disconnect and reconnect the battery, the procedure described in the workshop manual should be strictly adhered to . — Disconnect battery .
2. Remove steering column trim General body repairs, interior70Dash panel; Removing and installing steering column trim. [Note: The illustrations below are only schematic illustrations and specific details may vary.For reasons of clarity, the ignition/starter switch is shown without steering wheel and steering column switch module in the illustrations below.]
3. Pull out primary locking mechanism (1) of connector in (direction of arrow A).
4. Press primary locking mechanism (1) and pull connector (2) in (direction of arrow B) off ignition/starter switchD(3).
5. Remove anti-tamper paint from both clamping bolts (A).

6. Loosen clamping bolts (A) slightly and pull ignition/starter switchD(1) in (direction of arrow) out of steering lock housing.
7. ⚠ When installing the ignition/starter switch, ensure that the ignition/starter switch and the lock cylinder are in the same position, e.g. "“ignition on”". — Turn ignition key in lock cylinder to "“Ignition ON”" position.
8. Push ignition/starter switch into steering lock housing to stop.
9. Tighten clamping bolts and seal with anti-tamper paint.
10. Push connector onto ignition/starter switch and push in primary locking element.
11. Install steering column trim General body repairs, interior68Compartments/covers; Steering column trim.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Draining and filling ATF · 1 torque figures
• Cleaning evaporator in front heater and air conditioning unit using pressure-feed spray gunV.A.G 1538 and spray lance
• Dismantling and assembling drive shaft (triple roller joint AAR 3300 i)
• Draining fuel tank (fuel delivery unit defective) – Audi Q7
• Removing and installing pump V50 (vehicles with 6-cyl. engine) · 2 torque figures