Removing and installing headlight washer jet - vehicles with 3.0 ltr. TDI engine — AUDI

🧭 Before you start

Fits: Audi A8 D4 (4H, 2010–2017)

• Special tools named: 3094

Don't miss

• Place a cloth underneath to catch escaping fluid.

📋 Procedure

1. Disconnect earth cable from battery with ignition switched off .
2. Remove front impact bar General body repairs, exterior63Bumper (front); Removing and installing impact bar.
3. Release catch (arrow) and open cover (4).
4. Disconnect electrical wiring (1) and (2).
5. Remove bolt (3).

6. Slide fuse holder (front end) upwards and detach from lock carrier.
7. Unscrew bolts (arrows) on lower longitudinal member.
8. Release hose clip and remove charge air hose (1).
9. Pull lock carrier (4) forwards (arrow) so that bolts (3) on bracket (2) for charge air pipe can be removed.
10. Disconnect fluid hose (1) using hose clamp 3094. [Note: Place a cloth underneath to catch escaping fluid.]
11. Release retaining clip (3) and pull washer fluid hose (4) off washer jet.
12. Press retaining springs (1) on washer jet upwards to release (arrow) and at the same time take washer jet (2) out of retainer towards rear.
13. Retaining springs (3) and (4) on washer jet (2) will not engage audibly unless side guide (1) is correctly inserted in retainer (5).
14. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Oil pump, sump (bottom section) - exploded view · 5 torque figures
• Separating engine and gearbox - vehicles from model year 2014 onwards · 2 torque figures
• Adjusting final drive (if renewing differential or bearings for differential) · 2 torque figures
• Removing and installing leadthrough for coolant hoses and refrigerant lines to wheel housing (rear) · 2 torque figures
• Removing and installing suction-jet pump, vehicles with 3.0 ltr. (V6) or 4.2 ltr. (V8) engine) from 06.2010 onwards