Removing and installing headlight range control motor V48/V49 - halogen headlights — AUDI

🧭 Before you start

Fits: Audi Q3 (8U, 2011–2018); platform code 84

📋 Procedure

1. Remove headlight housing .
2. If fitted, remove bolts (1, 3).
3. Release retaining tabs (arrows) and detach housing cover (2).
4. Remove bolts (1, 4).
5. Press ball head of actuator shaft upwards out of its mounting by swivelling control motor and take out headlight range control motor (3).

6. Remove control motor.
7. Unplug electrical connector (2).
8. When inserting, plug in electrical connector.
9. Insert ball head of actuator shaft in mounting on reflector initially from below; to do so, pull reflector to rear.
10. Tighten bolts.
11. Install headlight housing .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing front right chest vent temperature sensor G386
• Removing and installing temperature sensor G18 and temperature sensor 2 for supplementary and auxiliary heating G587
• Removing and installing floor covering (front) – Audi Q7
• Removing and installing floor covering (rear) – Audi Q7
• Removing and installing backrest cover and padding - seat with pneumatic components