Removing and installing handset cradle with holder: Audi A3

🧭 Before you start

Fits: Audi A3 (8L, 1996–2003)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Detach mobile phone (1) from handset cradle (2).
4. Detach handset cradle (2) from adapter cradle (5) and unplug connector (3) at holder (6).
5. Screw out bolts (4) (2 Nm) and detach adapter cradle (5). — 2 Nm (1.5 lb-ft)
6. Screw out bolts (7) (2.5 Nm), detach holder (6) and unclip connector of telephone wiring harness (8). — 2.5 Nm (1.8 lb-ft)
7. Install accordingly in reverse order of removal.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Renewing engine control unit J623 (master control unit)
• Renewing engine control unit 2 J624 (slave control unit)
• Removing and installing electric drive motor V141 – Audi CHJA
• Checking secondary air pump relay J299 or J316 and activation
• Tightening torques for gearbox - Audi A4, Audi A5