Removing and installing guides for bumper: Audi A5 Cabriolet

🧭 Before you start

Fits: Audi A5 Cabriolet (8F)

📋 Procedure

1. Remove bumper cover (rear) (see the separate procedure).
2. Remove bolts (1 ... 3).
3. Release locking spring at bumper cover lock (arrow) and remove side mounting (4) for bumper cover downwards.
4. Install bumper cover (rear) (see the separate procedure).
5. Remove bumper cover (rear) (see the separate procedure).

6. Remove bumper cover mounting (side) (see the separate procedure).
7. Unscrew bolts (arrows) and detach lock (1) for bumper cover (front).
8. Install bumper cover mounting (side) (see the separate procedure).
9. Install bumper cover (rear) (see the separate procedure).
10. Remove bumper cover (rear) (see the separate procedure).
11. Unscrew nuts (arrows).
12. Detach guide (centre) (3).
13. Close rear lid.
14. Position guide (centre) and slide it upwards until assembly aids (1) and (4) make contact with rear lid (2).
15. Tighten nuts and break off the two assembly aids.
16. Install bumper cover (rear) (see the separate procedure).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Dismantling and assembling gearbox housing, selector mechanism, input shaft, output shafts (pinion shafts), differential, bevel box and selector rods
• Removing top part of sump – Audi A8 D2 2.8
• Removing and installing subframe - front-wheel drive – Audi
• 5-speed manual gearbox 085 DS — Exploded view of gear actuator · 5 torque figures
• Removing and installing toothed belt, vehicles 01.06 ►