Removing and installing fuel gauge senderG, all vehicles except versions for China — AUDI

🧭 Before you start

Fits: Audi Q3 (8U, 2011–2018); platform code 84

Don't miss

• When plugging in electrical connectors, make sure they engage correctly.

🔧 Engine codes this applies to

📋 Procedure

1. Observe safety precautions .
2. Observe rules for cleanliness .
3. Remove fuel delivery unit .
4. Release retainer catch and unplug electrical connector (2) on flange.
5. Cut through cable tie (3) and move clear electrical wiring.

6. Apply hook3438 in recess at side and release retaining tab (arrow A).
7. At the same time press out fuel gauge senderG(item 1) upwards (arrow B). [Note: When plugging in electrical connectors, make sure they engage correctly.]
8. Insert fuel gauge senderG into guides on fuel delivery unit and press downwards until it clicks into place.
9. Install fuel delivery unit .
10. Connect battery and perform steps required after re-connecting battery Electrical system27Battery; Disconnecting and connecting battery.

Other AUDI procedures

• Removing and installing activated charcoal filter - NAR vehicles
• Removing and installing engine control unit with protective housing, Passat, CC and Golf Cabriolet
• Emptying fuel tank with fuel tank less than 3/4 full, vehicles with front-wheel drive
• Removing and installing air mass meter – VW Jetta VI · 1 torque figures
• Removing and installing tensioner for poly V-belt (Golf, Eos, Scirocco)
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures