Removing and installing front sill mouldings — AUDI

🧭 Before you start

Fits: VW Caddy IV (SA, 2015–2020)

• Renewed: if necessary

Don't miss

• Before installing sill panel moulding, check retaining clips for damage and renew if necessary.Following installation, ensure that the A-pillars trim are positioned in door seal beading.

📋 Procedure

1. Remove dash panel end cover.
2. Remove A-pillar trim .
3. Remove B-pillar trim .
4. Switch off ignition.
5. Remove net partition .

6. Remove lower B-pillar trim, panel van .
7. Detach rear sill panel moulding in area of B-pillar .
8. Remove bonnet operating lever General body repairs, exterior55Bonnet; Removing and installing bonnet lock operating lever.
9. Unscrew pin from spreader rivet (1) and pull out from mounting.
10. Remove bolt (2).
11. Lever out sill panel moulding from mountings - in area of retaining clips - using a screwdriver. [Note: Before installing sill panel moulding, check retaining clips for damage and renew if necessary.Following installation, ensure that the A-pillars trim are positioned in door seal beading.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing air cleaner housing – Audi A6 C5 · 1 torque figures
• Checking injection quantity and spray pattern of injectors; checking for leaks · 1 torque figures
• Direct shift gearbox 02E, four-wheel drive — Exploded view - oil pan, mechatronic unit, gear oil pump · 3 torque figures
• Removing and installing convertible roof – Audi A3
• Removing windscreen – Audi A8 D3 · 1 torque figures