Removing and installing front passenger side airbag deactivated warning lamp K145 (vehicles from 06.04 onwards) — AUDI

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

Don't miss

• Use front-end hook3370 to carefully pull front passenger side airbag deactivated warning lamp K145 out of its mounting (arrow).

📋 Procedure

1. Switch off ignition and remove ignition key.
2. Remove radio 91.
3. Unclip trim for switch module at bottom (arrows 1).
4. Use front-end hook3370 to unclip trim for switch module at top (arrow 2).
5. Detach trim for switch module.

6. Unclip trim for switch module at bottom (arrow 1).
7. Use front-end hook3370 to unclip trim for switch module at sides (arrow 2).
8. Detach trim for switch module.
9. Use front-end hook3370 to carefully pull front passenger side airbag deactivated warning lamp K145 out of its mounting (arrow).
10. Unplug electrical connector.
11. Plug in electrical connector.
12. Press switch into mounting in dash panel and engage.
13. Install radio 91.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing vibration damper – Audi Q3 · 3 torque figures
• Audi 2.8 BDX/CJBA gearbox removal & installation · 1 torque figures
• Dismantling gearbox – Audi A6 C6 · 1 torque figures
• Removing and installing auxiliary/supplementary heater · 2 torque figures
• Removing and installing rear final drive 0DB, 0D2, Audi A4 · 2 torque figures