Removing and installing front interior light with roof electronics control unit J528 - vehicles up to 08.2007 — AUDI

🧭 Before you start

Fits: Audi A8 D3 (4E, 2002–2010)

📋 Procedure

1. If control unit is to be renewed, select the "“Replace control unit”" function for appropriate control unit in .
2. Continue to follow the instructions on the display of the vehicle diagnostic tester.
3. Switch off ignition and take out ignition key.
4. Carefully prise lenses (1) out of interior light on front edge using removal lever80 - 200 as shown in illustration.
5. Pry out switch trim with removal lever80 - 200 as shown in illustration.

6. Unscrew bolts (arrows).
7. Pivot front interior light downwards and remove from roof trim.
8. Unplug multi-pin connector.
9. Press retaining tab (1) at multi-pin connector.
10. Release retaining clips of connectors (arrow) and unplug connectors.
11. Unplug remaining electrical connectors.
12. Fit interior light and secure.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking lambda probe heating for lambda probes
• Checking accelerator position senders -G79 and -G185
• Power-assisted steering box for LHD vehicles with 12-cyl. petrol engine, removing and installing
• Replacing airbag units after accident
• Servicing suspension