Removing and installing front door — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

📋 Procedure

1. Remove wing triangular cover .
2. Remove dash panel trim on left side General body repairs, interior70Dash panel.
3. Release bellows (1) by pressing catch (2) on the side.
4. Pull bellows off A-pillar.
5. Disconnect connectors (arrows).

6. Fold floor covering in left footwell towards side.
7. Disconnect earth wire from star connection.
8. Guide lines through the hole.
9. Remove protective caps (3) and (5) (if there are any).
10. Remove bolt (4).
11. Remove bolt (6).
12. Lift door upwards out of hinges.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing intake air temperature sender G42 / intake manifold pressure sender G71
• Renewing stub shaft oil seal (right-side) with bevel box installed
• Removing and installing coolant pipe leading to alternator
• 6-cylinder direct petrol injection engine (3.2 ltr. 4-valve) — Securing engine to engine and gearbox support · 1 torque figures
• Removing and installing air filter element (right side) (cylinder bank 1)