Removing and installing front ashtray (vehicles with "“chorus”" and "“concert”" radio) — AUDI

🧭 Before you start

Fits: Audi A6 C5 (4B)

Don't miss

• When installing, ensure that guides (1) engage in centre console on left and right.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Unclip cover .
2. Unclip insert for centre console (2).
3. Open ashtray (front).
4. Unscrew bolt (1) (2x); tightening torque: 2 Nm. — 2 Nm (1.5 lb-ft)
5. Using a screwdriver (2), pull out retainers (1) (left and right) in direction of arrow.
6. Carefully pull air conditioner operating unit slightly towards rear, and pull out ashtray downwards and towards rear.
7. Pull ashtray towards rear and disconnect wires for cigarette lighter and ashtray light.
8. When installing, ensure that guides (1) engage in centre console on left and right.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing charge air cooler - vehicles without hybrid drive
• Filling and bleeding fuel system - vehicles without hybrid drive
• Removing and installing catalytic converter - vehicles with hybrid drive
• Removing and installing gearbox end cover – Audi A6/A7 C7
• Removing and installing honeycomb filter (USA vehicles with recuperation)