Removing and installing foot rest cover and bracket: Audi A6 C6

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

Don't miss

• Make sure lug (7) engages properly in opening in foot rest bracket (4).

📋 Procedure

1. Remove dash panel cover (bottom, driver side) .
2. Remove dash panel end trim .
3. Remove connecting piece .
4. Remove operating lever for bonnet cable .
5. Remove B-pillar trim (top).

6. Remove B-pillar trim (bottom) .
7. Remove A-pillar trim (bottom) .
8. Remove bolt (8).
9. Slide foot rest cover (1) upwards until lug (7) is disengaged from opening in foot rest bracket (4).
10. Take out foot rest cover (1).
11. Make sure lug (7) engages properly in opening in foot rest bracket (4).
12. Remove foot rest cover (1).
13. Fold back floor covering in area of foot rest.
14. Unscrew nuts (6) (3x).
15. Take out foot rest bracket (4).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing coolant pipe on gearbox (right-side) - vehicles with dual clutch gearbox 0B5/automatic gearbox 0BK
• Removing and installing convertible roof compartment seal
• Checking pressure signal at high-pressure sender G65 – Audi R8
• Removing and installing air conditioner compressor - vehicles with 6-cyl. engine
• Removing and installing bracket for control motor V427 / V443