Removing and installing floor covering, Roadster: Audi TT Mk2

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

Don't miss

• Make sure that floor covering does not tear at openings.

📋 Procedure

1. Remove seats (left and right) .
2. Remove dash panel cover (driver side) .
3. Remove accelerator pedal module 20Accelerator mechanism; Exploded view - accelerator pedal module.
4. Remove entire centre console .
5. Twist out studs (1) and detach cover for for universal joint on steering column.

6. Remove A-pillar trim (bottom, left and right) .
7. Remove back panel side trim (left and right) .
8. Remove sill panel trim (left and right) .
9. Remove foot rest cover .
10. Detach seat belt from outer belt end fitting .
11. Remove fasteners (2) (8x).
12. Unhook floor covering from retainers (1).
13. Disengage wiring harness from retainers.
14. Pull floor covering (3) towards rear. [Note: Make sure that floor covering does not tear at openings.]
15. Fold up floor covering lengthwise, guide it through beneath the wiring harness and take it out through one of the doors.
16. Fold up new floor covering lengthwise and place it in vehicle.
17. Start by sliding floor covering as far forwards as possible until hole patterns of accelerator pedal module, foot rest and cover for universal joint on steering column are aligned.
18. Then hook floor covering (3) into retainers (1).
19. Now fit fasteners (2) (8x).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures