Removing and installing fixed door-window — AUDI
Removing and installing fixed door-window on Audi: 18 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes S1, 2H
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 9 Nm (6.6 lb-ft) | Tighten bolts (3 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Removing rear door trim General body repairs, interior70Door trims.
- Remove inner film of rear door .
- Pull off inside door film.
- Remove inner window slot seal.
- Remove bolts (3).
- Rotate window bar (2) 90°.
- Guide window bar (2) upwards out of window guide.
- Roll window guide seal off sheet metal flange.
- Guide fixed door-window (1) upwards out of door (2).
- Guide door window (3) upwards out of door (2).
- Guide door window (3) downwards into door (2).
- Guide fixed door-window (1) into door (2).
- Roll window guide seal onto sheet metal flange.
- Rotate window bar (2) 90°.
- Guide window bar (2) at an angle upwards into window guide.
- Tighten bolts (3). Specified torque: 9 Nm — 9 Nm (6.6 lb-ft)
- Install inner window slot seal.
- Then perform remaining installation in reverse order of removal.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing fuel gauge sender 3G237 (up to model year 2013)
- Removing and installing rear fresh air blower V80 - vehicles with rear air conditioning unit
- Repairing 2.5 mm2, 4 mm2 or 6 mm2 aluminium wiring with single butt connector
- Adjusting clutch engagement mechanism (gearbox manufacturing date up to 05.2011)
- Checking fuel system pressurisation pump G6, vehicles with 3.0 ltr. (V6) or 4.2 ltr. (V8) engine from 06.2010 onwards
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.