Removing and installing filler pieces for lightweight rear seat backrest — AUDI
Removing and installing filler pieces for lightweight rear seat backrest on Audi: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A2 (8Z)
Don't miss
- Installation position: Marking must be legible when fitted.
📋 Procedure
- Removing and installing rear seat bench
- Removing and installing rear seat backrest
- Removing and installing cover and padding for rear seat backrest
- Detach upper outer filler piece (1) from diagonal section (7).
- Installation position: Marking must be legible when fitted.
- Jam upper outer filler piece (1) beneath diagonal section (7).
- Insert stud on filler piece -arrow A- in hole (arrow B) of backrest frame.
- Detach lower outer filler piece (2) from diagonal section (7).
- Installation position: Marking must be legible when fitted.
- Jam lower outer filler piece (2) beneath diagonal section (7).
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing magnetic coils for fuel tank shut-off valves N361/N362
- Removing and installing filler connection for natural gas tank
- Renewing needle bearings (polygon bearings) for stub shaft (right-side)
- Removing and installing gear sensor G676 and gear sensor 2G869
- Renewing oil seal for propshaft flange, Audi Q3
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.