Removing and installing door lock up to Model Year 2005: Audi A4 Cabriolet B6/B7

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H)

• Timing position: the crankshaft or camshaft is set and locked during this job
• Special tools named: locking pin

📋 Procedure

1. Remove the door trim 70.
2. Remove the door lock cap.
3. Remove the window lifter rear brace .
4. Unplug the connector at the door lock.
5. Unclip the Bowden cable for the interior door handle (5) at the door lock, swivel it through 90° and take it out of the actuating lever (4).

6. If same door lock is to be re-used, disengage operating rod at door handle.
7. If the door lock is to be replaced, unclip the operating rod at the sleeve from the door lock Engaging operating rod in door lock
8. Unscrew the bolts (1) and take out the door lock.
9. On installing new door lock, clip operating rod (1) into sleeve.
10. To lock operating rod, push slide (2) of sleeve upwards.
11. Pull locking pin (3) out of door lock.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing GPS aerial
• Removing and installing engine oil cooler (left-side) – Audi
• Removing and installing side panel (top) – Audi R8
• Removing and installing B-pillar trim – Audi R8
• Removing and installing brake pads (1KS) – Audi A1