Removing and installing D-pillar trim, Maxi — AUDI

🧭 Before you start

Fits: VW Caddy IV (SA, 2015–2020)

• Renewed: if necessary

Don't miss

• Before installing, check fasteners for damage and renew if necessary.

📋 Procedure

1. Remove window frame trim .
2. Remove fitting eyes for net partition .
3. Detach rear part of moulded headliner .
4. Fold up cap (4) of belt guide fitting (6).
5. Remove bolt (5).

6. Detach seat belt anchor from D-pillar.
7. Unscrew plastic pin (3).
8. Pull out spreader rivet (2) from mounting.
9. Detach remaining connections.
10. Detach D-pillar trim (1) from rear lid seal.
11. Remove D-pillar trim (1). [Note: Before installing, check fasteners for damage and renew if necessary.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing gearbox, Crafter 4MOTION with Achleitner four-wheel drive
• Removing and installing master cylinder with mounting bracket installed
• Adjusting selector mechanism in neutral selector lever gate for 1st and 2nd gear
• Audi A1 1.4 TSi dual-clutch (CAVG)
• Installing electrics kit