Removing and installing cover for fresh air intake: Audi Q3
Step-by-step removing and installing cover for fresh air intake for the Audi Q3: 5 steps, 1 torque figure.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi Q3 (8U, 2011–2018); platform code 84
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2.5 Nm (1.8 lb-ft) | Remove bolts (A |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove plenum chamber cover General body repairs, exterior50Bulkhead; Removing and installing plenum chamber cover.
- If fitted: Unplug electrical connector (2) from air quality sensor G238.
- Remove bolts (arrows).
- Detach cover (1). [Note: Water may flow into the fresh air intake duct if the cover is damaged or not fitted correctly. This may result in complaints about odour from the heater/air conditioner and/or moisture in the passenger compartment.Water may flow into the fresh air intake duct via the cover if the plenum chamber cover is damaged or not fitted correctly.]
- Install plenum chamber cover General body repairs, exterior50Bulkhead; Removing and installing plenum chamber cover.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing starter - Audi TT with 2.0 ltr. TDI engine and manual gearbox
- Removing and installing gearbox mounting - vehicles with 2.0 ltr. TDI engine
- 5-speed manual gearbox 02T — Dismantling and assembling output shaft
- Renewing rear bonded rubber bushes for subframe (multi-link suspension, four-wheel drive vehicle)
- Checking radiator fan valve N313 – Audi A8 D2 3.3 TDI AKF
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.