Removing and installing cover and padding for rear seat bench (5-seater) — AUDI

🧭 Before you start

Fits: Audi A2 (8Z)

• Renewed: staples

📋 Procedure

1. Remove rear seat (see the separate procedure).
2. Release rear seat backrest (see the separate procedure).
3. Use flat screwdriver to prise out piping (1).
4. Use flat screwdriver to prise out piping (2) all round.
5. Disengage cover from retainers (3) (2x).

6. Detach cover and padding (4).
7. Install cover and padding (4) in reverse order of removal.
8. Unfasten staples -2- from padding -3-.
9. Pinch off staples (4) and detach cover (1).
10. Use upholstery stapler V.A.G 1634/ to fit new staples.
11. To facilitate installation, push back longitudinal rods as far as first transverse rod.
12. When fitting, staple transverse rods first and then longitudinal rods.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing vehicle speed sender G68 and intermediate shaft speed sender G265 · 1 torque figures
• Removing and installing brake light switch on brake master cylinder · 1 torque figures
• Removing and installing handbrake cable – Audi A3
• Removing and installing drive shaft with intermediate shaft (version with bolted flange on inner joint)
• Removing and installing tyre pressure sensor – Audi A3 · 1 torque figures