Removing and installing console: Audi A6 C5
Step-by-step removing and installing console for the Audi A6 C5: 9 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6 C5 (4B)
Don't miss
- Always renew bolts (3).
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 23 Nm (17 lb-ft) | Tighten bolts (3) (4x) to a torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove seat .
- Position seat so that underside of seat cushion is easily accessible.
- Unfasten all cable ties attached to bracket.
- Unbolt connector point for electrical connector (two bolts).
- Detach both relays.
- Unscrew bolts (3) (4x) on bracket (1).
- Detach bracket (1) from seat (2). [Note: Always renew bolts (3).]
- Position new bracket (1) on seat (2).
- Tighten bolts (3) (4x) to a torque of 23 Nm. — 23 Nm (17 lb-ft)
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.