Removing and installing clutch slave cylinder together with release bearing — AUDI

🧭 Before you start

Fits: Audi A4 B9 (8W, 2015–)

• Opens: clutch fluid
• Renewed: o-ring

Don't miss

• Renew O-ring if damaged.
• Bleed clutch hydraulics after installing gearbox .

📋 Procedure

1. Release retaining clip (arrow) using a screwdriver and pull out as far as stop.
2. Pull off pipe/hose assembly or pipe (1).
3. Remove bolts (arrows).
4. Carefully take clutch slave cylinder off input shaft together with release bearing (A). [Note: In the event of leaks, renew input shaft oil seal Servicing 6-speed manual gearbox 0CS, 0DJ, 0CX39Oil seals; Overview of fitting locations - oil sealsPack space between sealing lips (arrow) of input shaft oil seal half-full with sealing grease.]
5. Carefully slide clutch slave cylinder with release bearing (A) along input shaft towards gearbox housing.

6. ⚠ Tighten securing bolts (arrows) for slave cylinder in small steps. — Tighten securing bolts (arrows) to specified torque. [Note: Renew O-ring if damaged.]
7. Fit pipe/hose assembly or pipe (1) into connection of clutch slave cylinder.
8. Press in retaining clip (arrow) as far as stop.
9. Pull on pipe/hose assembly or pipe to check it is secure.
10. Bleed clutch hydraulics after installing gearbox .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing fuel gauge sender 3 G237 (up to model year 2013)
• Adjusting selector mechanism (vehicles from 11.00 onwards)
• Removing and installing washer fluid reservoir – Audi A4 B8
• Removing and installing mechanical exhaust gas recirculation valve
• Removing and installing tandem pump - Vehicles with 6-cyl. engines