Removing and installing clutch pedal with extension spring - vehicles up to model year 2014 — AUDI

🧭 Before you start

Fits: Audi A1 (8X, 2010–2018)

• Renewed: pivot pin

Don't miss

• Right side of illustration (arrows) is only relevant for installation.
• Retainers (A) will be destroyed when you do this.Renew pivot pin.
• Renew pivot pin.Grease mountings for extension spring.

📋 Procedure

1. Remove dash panel cover (driver side) General body repairs, interior68Shelves / trim panels; Removing and installing dash panel cover (driver side).
2. Remove crash bar General body repairs, interior70Central tube for dash panel; Exploded view - central tube for dash panel.
3. Disengage extension spring using hook3438. [Note: Right side of illustration (arrows) is only relevant for installation.]
4. To release operating rod for clutch master cylinder, pull clutch pedal slightly towards passenger compartment.
5. Press both sides of retaining clip inwards using pliers T10005(arrows).

6. Using 8 mm Allen key (item 1), turn pivot pin for clutch pedal anti-clockwise (arrow) until ears (B) are horizontal. [Note: Retainers (A) will be destroyed when you do this.Renew pivot pin.]
7. Move clutch pedal back and forth to pull out pivot pin.
8. Remove clutch pedal. [Note: Renew pivot pin.Grease mountings for extension spring.]
9. Bring clutch pedal into position at clutch master cylinder.
10. Insert new pivot pin in mounting bracket and clutch pedal.
11. Using 8 mm Allen key (item 1), turn pivot pin for clutch pedal clockwise (arrow) until ears (A) are vertical.
12. Engage clutch pedal at mounting on master cylinder operating rod.
13. Hook in extension spring.
14. Insert vibration damper so that 2nd spring coil (right arrow) is at recess (left arrow) (in illustration) of vibration damper.
15. Install crash bar General body repairs, interior70Central tube for dash panel; Exploded view - central tube for dash panel.
16. Install dash panel cover (driver side) General body repairs, interior68Shelves / trim panels; Removing and installing dash panel cover (driver side).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Exploded view - poly V-belt drive · 5 torque figures
• Exploded view - cylinder block (gearbox end) · 5 torque figures
• Measuring radial clearance – Audi A6 C5 · 5 torque figures
• Removing and installing balance shaft assembly with chain drive · 3 torque figures
• Removing and installing rear window – Audi A5 · 1 torque figures