Removing and installing centre console without extension — AUDI
Removing and installing centre console without extension on Audi: factory workshop procedure. Full factory text, tools and checks.
Workshop procedure for AUDI — the factory write-up, straight from real workshop data.
📋 Procedure
Audi
Audi A8
2003
Body
General body repairs, interior
Edition
07.2011
Removing and installing centre console without extension
Overview
Chapter
„
Centre console without extension - overview of fitting locations
“
Chapter
„
Exploded view of centre console without extension
“
Chapter
„
Removing and installing centre console
“
Chapter
„
Removing and installing floor covering rod (rear and front)
“
Chapter
„
Removing and installing air conditioner operating unit (front)
“
Chapter
„
Removing and installing ashtray (front)
“
Chapter
„
Renewing trim for ashtray (front)
“
Chapter
„
Removing and installing cigarette lighter (front)
“
Chapter
„
Removing and installing trim for centre console with multimedia operating unit
“
Chapter
„
Removing and installing front centre console cup holder
“
Chapter
„
Removing and installing rear vent (2-zone climate control)
“
Chapter
„
Removing and installing trim for rear centre console (rear vent, 2-zone climate control)
“
Chapter
„
Removing and installing rear cigarette lighter (rear vent, 2-zone climate control)
“
Chapter
„
Removing and installing storage compartment (rear)
“
Chapter
„
Renewing trim for storage compartment (rear)
“
Chapter
„
Removing and installing centre console storage compartment (one-piece centre armrest)
“
Chapter
„
Removing and installing centre console storage compartment (split centre armrest)
“
Chapter
„
Removing and installing rear vent (4-zone climate control)
“
Chapter
„
Removing and installing rear air conditioner operating unit (4-zone climate control)
“
Chapter
„
Removing and installing rear cigarette lighter (rear vent, 4-zone climate control)
“
Chapter
„
Removing and installing trim for rear centre console (rear vent, 4-zone climate control)
“
Chapter
„
Removing and installing rear air distributor and rear air duct (2 and 4-zone climate control)
“
Chapter
„
Removing and installing rear vent warm air and cold air flap control motor (left-side/right-side)
“
Chapter
„
Removing and installing rear centre console temperature sensor (left-side/right-side)
“
TorqFix answers live for your specific car — tell it the engine code and it serves the matching sequence, torque figures and wiring for that exact variant.
Ask about my car →Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.