Removing and installing cable for door opener — AUDI

🧭 Before you start

Fits: platform code 42

📋 Procedure

1. Remove door trim 70.
2. Remove cover panel for door shell .
3. Remove anti-theft cover panels .
4. Remove bolts (arrows).
5. Press door lock (1) to the side and, if necessary, unplug electrical connector (2).

6. Disengage cable (3) from door lock support bracket (2)(arrow A).
7. Turn nipple (1) 90° in direction of (arrow B) and take it out of door opener release lever (4).
8. Insert nipple (2) in door opener release lever (3)(bottom arrow).
9. Turn nipple 90° (top arrow) and press cable into cable support bracket on door lock (1) until it engages audibly.
10. Install anti-theft cover panels .
11. Install cover panel for door shell .
12. Install door trim 70.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Servicing steering rack – Audi Q3
• Removing and installing bumper cover mounting (bottom) – Audi
• Removing and installing sliding sunroof seals – Audi Q3
• Removing and installing water drain hose (front) – Audi Q7
• Removing and installing wheel arch cover (rear) – Audi Q3