Removing and installing button for release mechanism — AUDI

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

Don't miss

• After prising the rear lugs out of the release mechanism, the long-arm spring (2) and the rocker (3) automatically become disengaged from the button (1).
• Make sure the long-arm spring is properly engaged in the button.

📋 Procedure

1. Remove trim (left-side/right-side) .
2. Use removal wedge3409 to first prise button (1) at rear out of release mechanism (2).
3. Start by prising out lug (arrow) facing centre of vehicle.
4. Then prise out lug (arrow) facing towards outside of vehicle. [Note: After prising the rear lugs out of the release mechanism, the long-arm spring (2) and the rocker (3) automatically become disengaged from the button (1).]
5. Then use removal wedge3409 to prise front lugs of button out of release mechanism in the same sequence.

6. Detach button from rocker.
7. Slide button from rear onto rocker (2) and long-arm spring (3).
8. Use removal wedge3409 to engage rear lugs in release mechanism (left and right).
9. Use removal wedge3409 to engage front lugs in release mechanism (left and right).
10. Make sure the long-arm spring is properly engaged in the button.
11. Install trim (left-side/right-side) .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures