Removing and installing brake pedal, vehicles with manual gearbox — AUDI
Removing and installing brake pedal, vehicles with manual gearbox on Audi: 13 steps, 1 torque figure.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A4 B9 (8W, 2015–)
Don't miss
- Do NOT grease or oil pivot pin and pin mounting on brake pedal.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 20 Nm (15 lb-ft) | Tighten retaining bolt |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove dash panel cover General body repairs, interior68Shelves/trim panels; Removing and installing dash panel cover (driver side).
- Remove footwell vent Heating, air conditioning87Air duct system; Removing and installing footwell vent (driver side).
- Separate brake pedal from brake servo .
- Remove mounting bracket .
- Release retaining bolt (arrow) and detach retaining clip (2).
- Pull pivot pin (3) off towards left and detach brake pedal (1). [Note: Do NOT grease or oil pivot pin and pin mounting on brake pedal.]
- Fit brake pedal in mounting bracket.
- Slide pivot pin (3) in from left as far as stop and secure with retaining clip (2) and retaining bolt (arrow).
- Tighten retaining bolt (20 Nm). — 20 Nm (15 lb-ft)
- Install mounting bracket .
- Connect brake pedal to brake servo .
- Install footwell vent Heating, air conditioning87Air duct system; Removing and installing footwell vent (driver side).
- Install dash panel cover General body repairs, interior68Shelves/trim panels; Removing and installing dash panel cover (driver side).
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing intake manifold with fuel rail, cylinder bank 2 (left-side)
- Servicing gearbox cover
- Dismantling and assembling piston/cylinder "„D"" – Audi
- Removing and installing vacuum pump, 2.0 ltr. TDI engine
- Removing and installing sunroof panel (rear) – Audi Q5 · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.