Removing and installing brake pedal: Audi A6/A7 C7
Step-by-step removing and installing brake pedal for the Audi A6/A7 C7: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X
📋 Procedure
- Remove mounting bracket .
- Slacken retaining bolt (3) for pin.
- Pull both securing clips (1) off pin.
- Slide pin (5) out of brake pedal (2) and mounting bracket (4).
- Take off brake pedal.
- ⚠ If possible, leave the stop fitted on the brake pedal. The mounting for the brake light switchF could break off if the brake pedal is released too abruptly. — Push retaining clip (right-side) onto pin.
- Slide pin from right to left through shaft in brake pedal.
- Secure pin with retaining clip (1) on left side.
- Fit bolt (3) and tighten.
- Install mounting bracket .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Repairing a wire of 0.22 mm2 section by connecting in an additional wire
- Removing and installing automatic gearbox control unit J217
- Servicing 6-speed manual gearbox 0A2, front-wheel drive — Servicing gearbox housing
- Removing and installing rear splined shaft, oil seal and ball bearing
- Removing and installing oil pump and suction-jet pump
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.