Removing and installing bracket for manual operation: Audi Q5

🧭 Before you start

Fits: Audi Q5 (8R, 2008–2017); platform code 83

Don't miss

• If the cable cannot be disengaged as described, the bumper cover (rear) must be removed .

📋 Procedure

1. Remove bolts (arrows).
2. Detach cover (1) for towing bracket Owner's Manual.
3. Pull mounting for cable support bracket off studs.
4. Release fasteners and open cover (1)(arrow).
5. Take cable support bracket (2) out of cable mounting.

6. Disengage cable nipple (3) from mounting (4).
7. Push grommet through to the inside. [Note: If the cable cannot be disengaged as described, the bumper cover (rear) must be removed .]
8. Open cover for luggage compartment side trim.
9. Take out vehicle tool kit, release clamping washers and remove mounting for vehicle tool kit.
10. Pull off securing clip (6) and detach operating lever (5).
11. Unplug electrical connector.
12. Remove bolts (4).
13. Push bracket (1) for manual operation of towing bracket slightly upwards and remove.
14. Take out bracket with cable (7) and grommet (8).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing coupling rod
• Removing and installing upper transverse link, front-wheel drive vehicles
• Dismantling and assembling drive shaft with 82 mm dia. outer constant velocity joint
• Checking inner constant velocity joint – Audi A1
• Removing and installing guide rail for door window – Audi