Removing and installing belt buckles with buckle bracket (left-side) — AUDI
Removing and installing belt buckles with buckle bracket (left-side) on Audi: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6 C6 (4F, 2004–2011)
📋 Procedure
- Remove rear seat bench .
- Remove bolt (2).
- Take out belt buckles with buckle bracket (left-side) (1).
- Insert bolt (2) in hole in buckle bracket.
- Push seal (3) onto shank of bolt as far as it will go.
- Insert bolt (2) into nut on vehicle floor.
- Press buckle bracket against vehicle floor.
- Align recesses in buckle bracket (arrows A) with locating elements on vehicle floor (arrows B).
- Tighten bolt (2) to specified torque.
- Install rear seat bench .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing amplifier R12 (Avant) – Audi A4 B6/B7 · 1 torque figures
- Removing and installing aerial amplifier for mobile telephone R86 (Saloon) · 1 torque figures
- Checking compression - engine codes AVB, AVF and AWX – Audi
- Removing and installing loudspeaker in rear side trim – Audi · 1 torque figures
- Removing and installing BOSE amplifier (as of MY 99) – Audi A3 · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.