Removing and installing bearing for flange shaft (right-side) — AUDI
Removing and installing bearing for flange shaft (right-side) on Audi: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi R8 (4S, 2015–)
📋 Procedure
- Remove flange shaft (right-side) .
- Remove circlip (arrow).
- Set up special tools.
- Press out ball bearing.
- Set up special tools.
- Press in ball bearing onto stop.
- Install circlip (arrow).
- Install flange shaft oil seal (right-side) .
- Install flange shaft and fit circlip.
- Install flange shaft with cover for final drive .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing gearbox (vehicles with 2.0 ltr. TFSI engine) – Audi
- Removing gearbox (vehicles with 1.9/2.0 ltr. TDI unit injector engine)
- Removing gearbox (vehicles with 2.0 ltr. TDI common rail engine)
- Removing and installing toothed belt (vehicles with separate toothed belt covers)
- Removing and installing camshafts, engine codes BZB, CAWB, CBFA, CCTA, CDAA, CCZA
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.