Removing and installing bass loudspeaker: Audi A2
Step-by-step removing and installing bass loudspeaker for the Audi A2: 7 steps, 3 torque figures. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A2 (8Z)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1.5 Nm (1.1 lb-ft) | Remove bolt (1) (3x |
| 3 Nm (2.2 lb-ft) | Unfasten nuts (2 |
| 6 Nm (4.4 lb-ft) | Screw out the four bolts (1 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off all electrical equipment.
- Remove ignition key.
- Remove load compartment floor in luggage compartment General body repairs, interior70.
- Screw out the four bolts (1) (6 Nm). — 6 Nm (4.4 lb-ft)
- Take out bass loudspeaker (2).
- Unplug connector.
- Install accordingly in reverse order of removal.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing burner element – Audi A6/A7 C7
- Removing and installing O-ring on cover for front final drive
- Removing and installing support mounting (right-side) – Audi
- Connecting and disconnecting modular wiring
- Removing and installing rear seat backrest contact switch - "High" outer seat in 2nd row
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.