Removing and installing base for shift unit: Audi Q7

🧭 Before you start

Fits: Audi Q7 (4L, 2005–2015)

Don't miss

• The centring bracket is only required for production purposes.
• Make sure seal is properly seated on base for shift unit.

📋 Procedure

1. Remove shift unit .
2. Press rubber sleeve (arrow) forwards out of base for shift unit.
3. Detach retaining hooks (1) and (2).
4. Remove bolts (arrows).
5. Pull base (1) for shift unit slightly towards rear and unscrew bolts (arrows) for centring bracket (2).

6. Lift off base for shift unit.
7. Lift off centring bracket (does not have to be re-installed). [Note: The centring bracket is only required for production purposes.]
8. Make sure seal is properly seated on base for shift unit.
9. Carefully insert rubber sleeve (arrow) on selector lever cable into base for shift unit all around.
10. Install shift unit .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing coolant pipe (left-side) – Audi Q7
• Dismantling and assembling input shaft – Audi A5 / A4 B8 · 1 torque figures
• Valve gear - exploded view · 4 torque figures
• Installing gearbox - vehicles with 1.6 ltr. TDI engine – Audi
• Removing and installing gearbox bracket – Audi TT Mk1