Removing and installing ATF lines - vehicles with 2.0 ltr. TFSI engine — AUDI

🧭 Before you start

Fits: Audi Q5 (8R, 2008–2017); platform code 83

• Renewed: o-rings

Don't miss

• Mark relative position of ATF lines before removing to avoid interchanging.
• Place used oil collection and extraction unitV.A.G 1782 or drip tray below gearbox to catch escaping ATF.

📋 Procedure

1. Remove noise insulation (1) and (2)General body repairs, exterior66Noise insulation; Removing and installing noise insulation.
2. Place used oil collection and extraction unitV.A.G 1782 below respective connection in ATF lines. [Note: Mark relative position of ATF lines before removing to avoid interchanging.]
3. Disconnect ATF return line (1) and supply line (2).
4. Remove securing bolts (arrows) for ATF lines on engine. [Note: Place used oil collection and extraction unitV.A.G 1782 or drip tray below gearbox to catch escaping ATF.]
5. Detach clip (A) for wiring harness for mechatronic unit from ATF line (B).

6. Remove bolt (arrow) and detach ATF lines (B) and (C) from gearbox.
7. Seal off open lines and connections with clean plugs from engine bung setVAS 6122.
8. Take out ATF lines towards front. [Note: Renew O-rings.]
9. Check ATF level .
10. Install noise insulation General body repairs, exterior66Noise insulation; Exploded view - noise insulation.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Finish balancer · 3 torque figures
• Audi Vehicles with 4-cyl. auxiliary belt replacement · 2 torque figures
• Audi Vehicles with 1.8 l, 2.0 l auxiliary belt replacement · 2 torque figures
• Drive shaft / wheel hub splines · 2 torque figures
• Audi Vehicles with 1.9 l TDI auxiliary belt replacement · 2 torque figures