Removing and installing alternator, vehicles with TSI engine — AUDI

🧭 Before you start

Fits: platform codes SF, SG

Don't miss

• The hoses attached to power steering vane pump do not have to be detached.When doing this, the hoses on the vane pump must not be kinked or stretched.

📋 Procedure

1. Disconnect batteries .
2. Remove poly V-belt 13Cylinder block on pulley side; Removing and installing poly V-belt.
3. Unscrew power steering vane pump from bracket Running gear, axles, steering48Hydraulic power steering; Removing and installing vane pump. [Note: The hoses attached to power steering vane pump do not have to be detached.When doing this, the hoses on the vane pump must not be kinked or stretched.]
4. Release and disconnect connector of DF cable (1).
5. Remove protective cap (1) and unscrew nut securing terminal 30 cable connection.

6. If fitted, release and separate electrical connector (1) on oil filter housing.
7. If fitted, detach cable connection from alternator (1) and push cable aside.
8. Unscrew upper securing bolts (1) on alternator.
9. Unscrew lower securing bolts (1) on alternator.
10. Take alternator out downwards.
11. After completing work, start engine and check if belt runs properly.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing belt buckle (standard seat and seat with seat memory)
• Removing and installing side airbag (seat with electrical adjustment)
• Removing dash panel fastener (centre) – Audi · 1 torque figures
• Aligning tailpipes - vehicles with visible tailpipes · 1 torque figures
• Checking exhaust gas temperature sender G235 and G236