Removing and installing alternator - vehicles with 2.0 ltr. TFSI engine — AUDI

🧭 Before you start

Fits: platform code FV

📋 Procedure

1. Disconnect earth cable from battery with ignition switched off .
2. Remove bolts (1, 2).
3. Release hose clips (1, 2) and remove air hose.
4. Seal off open pipes and connections with clean plugs from engine bung setVAS 6122.
5. Vehicles with two fans: Remove radiator cowl 19Radiator/radiator fans; Removing and installing radiator cowl.

6. Move clear coolant hose (3).
7. Release hose clip (2).
8. Remove bolts (arrows).
9. Unplug electrical connector (1).
10. Remove air pipe (right-side).
11. Detach air conditioner compressor at bracket and lower slightly Heating, air conditioning87Air conditioner compressor; Detaching and attaching air conditioner compressor at bracket.
12. Move electrical wiring harness clear (arrow).
13. Remove bolts (5, 6) and move alternator (4) forwards.
14. Unplug electrical connector (3).
15. Pry off cap (2).
16. Unscrew nut and remove terminal 30/B+ (item 1).
17. Remove alternator downwards and to the right.
18. Connect battery. Steps required .
19. Start engine and check that belt runs properly.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing fuel pressure sender G247 – Audi A3
• Removing and installing toothed belt for coolant pump – Audi
• Removing and installing navigation system aerial R50 – Audi A3 · 1 torque figures
• Removing and installing key-operated switch to deactivate airbag on front passenger side E224
• Removing and installing A-pillar trim (top) – Audi A6 C6